Don't have PayPal account, Need faster delivery
service, or need to drop ship to other location pleaseclick here
To view how the hopper works
please go to the bottom of the page.
Features a slide out
4 hole spray tip plate.
No tools needed.
4 removable stainless
steel air jet nozzles for
easy clean out.
air jets to use with small
air compressore that
deliverds only 4-6 cfm
@ 90 psi.
NEW hopper includes 2
cover bolts that allow you
to plug one or two holes at
the tip for narrow spraying
Swivel between handle
and hopper for easy
installation and removal.
1/2" x 1/2" adapter to use
on tight areas when there
is no room for the
Proudly made in the USA.
Our Stucco Sprayer Hopper Gun can be used for plastering a stucco house, traditional plastering of stuccos such as one
coat or three coat stucco or GFRC.
The range is from 1/8" heavy texture to 1" thick structural layers.
It can also be used for applying plaster, hard coat stucco, EIFS, small scale shotcrete, papercrete, earthen mixes and more.
Hopper made from stainless steel material, with a life time anti-rust guarantee.
Sand /Cement Slurries, plaster
spray products, Grout, GFRC, GFRG
Monokot Mk-6, Cafco-300, and other
For best performance we recommended to use 12 cfm @ 100 psi
(340 liter@ 7 bar)
gas power or electric air compressor, with 15 to 30 gallon
(60-114 liter) air tank. We also include 4 additional brass air jets to use with small air compressore that delivers only 4-6 cfm @ 90 psi.
When need to spray ceiling just tape 3" at the back of hopper, so material will not spill when lifting the hopper on angel.
For extra hopper care and easy clean use LPS-3 before use.
Top-Notch, Two Years Limited Warranty. (Excluding Consumable Components)
Covers All Parts and All Repairs,
The stucco sprayer arrived yesterday morning and was immediately put to use. Once I established the best speed and pulsed the air flow it was absolutely brilliant. I applied a key coat to a two storey external wall of my house and managed to complete the job in around 45 minutes – this would normally take half a day or more to splash a key coat on by hand with a trowel or dash brush and there would be a lot more product on the ground doing it that way. In fact, it took me longer to clean up the mixer and buckets than it did to spray the wall!